30
ABBRA INSTALLATION
depending on the setting of an on-board
“DIP” switch.
MCT-100
D. Wireless Smoke Detector
MCT-4
30
(UL-listed)
.
A
photoelectric
smoke
detector
equipped with a PowerCode-type
transmitter. If enrolled to a fire zone,
it initiates a fire alarm upon
detection of smoke.
MCT-430
E. Glass Break Detector MCT-501
(not UL-Listed).
An acoustic detector
equipped
with
a
PowerCode-type
transmitter. Since it restores automatically
after detection, this unit does not send a
restoral message to the control panel.
MCT-501
E2
Abbra Compatible Transmitters
Note:
Each transmitter is packed with its own instructions
for battery installation and use. Be sure to pass these
documents on to the “Master User“ of the alarm system.
The Abbra system is compatible with multi-button and
single button key-ring and hand-held transmitters that use
PowerCode and CodeSecure coding methods.
Multi-button PowerCode transmitters transmit the same
code each time the same button is pressed. They can be
used for emergency signaling, for activating the PGM
output or for controlling appliances via X-10 units.
They
can not be used for arming / disarming.
CodeSecure transmitters are of the rolling code type - they
transmit a new code each time the same button is pressed.
This provides a higher security level, especially in arming /
disarming applications, because the code can not be
copied (“grabbed”) by unauthorized people.
Following are the basic details of several compatible
transmitters. The possible applications for each push-
button are indicated in each drawing.
A. MCT-234
‘Keyfob’
transmitter - one unit is
supplied with Abbra. You can
program the AUX (auxiliary)
button to perform various tasks,
in accordance with the user’s
needs.
Pressing AWAY and HOME
together for 2 sec. initiates
PANIC alarm. Pressing AWAY
for 2 sec. initiates Latchkey
arming.
DISARM
AWAY
AUX
HOME
MCT-234
B. MCT-231 / 201*
(N.A. in North America)
Single-button pendant units.
The
MCT-231
(Code-
Secure) and the MCT-201
(PowerCode) can be enrolled
to
perform
functions
as
shown. Both units look alike.
MCT-231 / 201
* Not UL listed.
C. MCT-134 / 104*
(N.A. in North America)
4-button hand-held units. MCT-
134 (CodeSecure) can replace
the MCT-234 keyfob. MCT-104
(PowerCode)
can
perform
emergency and non- alarm
functions. Both units look alike.
MCT-134
/
104
D. MCT-132 / 102*
(N.A. in North America) 2-
button
units.
MCT-132
(CodeSecure) can perform
functions as shown.
MCT-102
(PowerCode) can perform
emergency and non-alarm
tasks. Both units look alike.
MCT-132
/
102
E. MCT-131 / 101*
(N.A. in North America) Single-
button units. The MCT-131
(CodeSecure) and the MCT-
101 (PowerCode) can be
enrolled to perform functions as
shown. Both units look alike.
MCT-131
/
101
F. MCT-211*
Water-proof,
wrist-worn
Power -Code transmitter. Can
be
enrolled
to
perform
emergency
or
non-alarm
functions.
MCT-211
*
Not UL-listed - not to be used in UL-listed systems
E3 Abbra Compatible WL Siren
The MCS-700 (*) wireless siren can be
integrated with the Abbra in areas in which
wiring action is difficult or impossible. The
MCS-700 is a fully supervised, 2-way
communication device (it includes a receiver,
to receive activation commands from the
alarm system, and a transmitter to periodically
transmit its status signal to the alarm system).
Wireless
Siren
When an identifiable activation command is received from
the Abbra, the siren activates its sounder and the flash light
(strobe light every 1.5 seconds).
*
Not UL-listed - not to be used in UL-listed systems
E4. Abbra Compatible GSM Modem
The GSM modem enables the
Abbra system to operate over a
cellular
network.
For
details
regarding
the
GSM
modem
features and connections, refer to
the
GSM
Modem
installation
instructions.
GSM Modem
