1YSA160045-EN - Rev. 5
7 / 33
C.4.3.
Opening of the Unit
Remove the top cap using a 34mm fork spanner holding the tube with the hand. Check condition of O-ring, and replace it if
necessary, applying grease on it.
Figure 1.
Connect the micro-USB cable to calibrate the current, set counting operations, tripping mode, network id and frequency. This
connection can be used to download the events.
Note: Handle with care without damaging the micro-USB connector.
Figure 2.
C.4.4.
wiAutoLink Configuration Tool
C.4.4.1.
Installation
The WACT tool requires a computer with windows operating system, with USB port and the framework .NET 4.0. The application
should be installed following this procedure:
1.
Connect the computer to Internet.
