3. Select and enter the data for these subjects:
•
OCPPJID
•
OCPPJURL
•
OCPPJPassword
•
Confirm password
4. Make sure that you type the URL or ID correctly and without spaces.
5. Obey the maximum number of allowed characters for URL and ID, that is 40.
6. Select
Set OCPP parameters to confirm the configuration parameters that you
entered.
7. Select
Save to save your changes.
6.7.4
Install new software
1. On the hardware screen, select
Trigger discovery.
The screen gives feedback if the trigger discovery has been started or failed. The
system tries to discover new hardware, installs software on the hardware and
assigns node IDs. During this discovery, the local service portal is closed. The
screen shows the message
Out of order.
2. Do not turn off the EVSE during the discovery process.
3. Wait until the discovery process is finalized.
The discovery of new hardware can take up to 15 minutes. At the end of
the discovery process, the new software is installed. The system starts the
processes again in the background and the screen goes into idle mode.
6.7.5
Close the local service portal
1. On the touchscreen, select
Exit.
2. Select
Confirm in the dialog box.
The HMI will switch to the user application. After 5 minutes of touch inactivity on
the screen, the local service portal will close. The HMI will switch to the regular
EVSE application.
3. If the local service does not close automatically, select the
Trigger Discovery
button.
Operation
42
9AKK108467A6997-EN | 003