BUSCH-/ABB-SECURE@HOME
2CSM600727D0901
10/74
2.1.4
Status of the individual zones
The status of the zones can be accessed by pressing the
key on the idle screen: each zone
can assume the statuses - and therefore the icons - described in the "Intrusion alarm system"
section of the
Meaning of the icons table - par. 2.1.1.
2.2
LEDs
4 LEDs are located beside the display, on the right.
Indicates that the central unit battery is faulty.
Indicates that mandatory notifications have been stored and not yet viewed. Visible when the
system is deactivated.
Signals an alarm (intrusion, tampering).
Does not signal burglar alarms. Only visible to authenticated users.
Signals system jamming.
In the event of a fault or an alarm, the relevant LED will come on and stay on, unless the
network power supply is not working and only battery power supply is available. If this is the
case, the LEDs will flash slowly (2 seconds on, 6 seconds off) to save power. The notification
LED will switch off automatically when all of the pending faults have been viewed by scrolling
through the various screens using the ‘
>
’ key and returning to the main screen.
In the event of alarms (tampering or intrusion), the LED will only switch off following the
restoration operation.
