Document type
Document identity
Revision
Page(s)
Instruction manual for MACHsense-R - MSR1600
1MZB100400
A
16(31)
We reserve all rights in this document and in the information contained therein. Reproduction, use or disclosure to third parties without
express authority is strictly forbidden.
© Copyright 2017 ABB
PROPRIETARY AND SECRET INFORMATION
DAU Mounting Holes and Space Requirements
Small clamp to be welded to the base with 20 mm projection from left and right sides,
horizontal hole pitch is 260 mm.
Vertical hole pitch is 200 mm when the clamps are aligned 42.5 mm from the top and
bottom sides of the baseplate.
L bracket to be welded to the base with 12.5 mm projection from the edge.
Following precautions have to be taken into account while mounting DAU:
·
Select mounting location which is a non-hazardous areas and free of shock forces, excessive
dust, close proximity to electrical appliances, etc.
·
Selected mounting location and subsequent mounting of DAU should allow trouble free cabling.
·
The DAU should be mounted where it is easy accessible for service technician to connect laptop
into the LAN connector inside the DAU.
·
Sufficient reserve should be provided for connectors.
·
Ensure correct fastening of mounting bolts to prevent any sudden unfastening due to external
forces.
·
Ensure proper laying of cables. Use cable ties and fasteners to secure the cables.
·
Mounting directly on motor should be avoided. For further instructions please consult Motor
manufacturer for mounting instructions.
6.3 Communications
The DAU communicates with the specific server over a
General Packet Radio Services
(GPRS)
connection. A SIM card is required for the GPRS or 3G connection.
In addition to GPRS it will be enabled to use
Wireless Local Area Network
(WLAN) or Ethernet.
6.4 Example of Installation
·
The DAU can be mounted on assembly plate of the motor. Drilling and tapping of holes will be
required for this. Motor manufacturer should be consulted.
