2TLC010040M0201 Rev. A
www.abb.com/jokabsafety
3(4)
3.
Mount positioning/stop screw (1 pce 4,2x16 and 3
pcs DA2) for the anchor plate.
4.
Pre-assemble the anchor plate with cellular rubber.
Tighten the screws by hand, do not use any tool.
IMPORTANT!
Over tightening might deform the anchor plate,
with decreased holding force as result. A
deformed anchor plate has to be replaced.
5.
Insert/slide the anchor plate in to the handle
profile.
6.
Mount the positioning/stop screw (1 pce 4,2x16
and 3 pcs DA2) for the anchor plate.
7.
Pre-assemble the handle profile using a M6-
mounting kit.
8.
Mount the two end caps using self-tapping screws
3,2x13 (x6).
Note!
End cap with opening for cable can be
mounted on any profile end. The fourth screw is
mounted later on (see step 11)
