ABB IRB 6640 Foundry Prime, Руководство по эксплуатации продукта

Страница: 352 / 496

Note Action
Lift the motor and put it on the guide pins as
close as possible without pushing the motor
pinion into the gear. 7
Make sure that the motor is turned the right
way - that is with cables facing downwards.
Remove the lifting tool and allow the motor to
rest on the guide pins. 8
For article number see:
• Required equipment - tools etc.
on page 347
xx0200000165
Use the rotation tool in order to rotate the motor
pinion when mating it into the gear.
When the motor is pushed in position make
sure the motor pinion is properly mated to the
gear of the gearbox.
Be careful not to damage gears in the process.
9
Part:
• A: Rotation tool
Remove the guide pins. 10
M10x40 Secure the motor with its attachment screws
and plain washers .
11
4 pcs
Tightening torque: 50 Nm.
Reused screws can be used providing
they are lubricated as described in
section
Screw joints on page 461 before
fitting.
Disconnect the 24 VDC power supply. 12
Connecting motor axis 2
Use this procedure to connect all connectors on motor axis 2.
Note Action
For article number see:
• Required parts on page 346
Install a new gasket in the cable gland. 1
Connect in accordance with the mark-
ings on connectors. Connect all connectors on motor axis 2. 2
Refit the cable gland cover at the cable exit. 3
Make sure the cover is tightly sealed. Refit the cover of the motor with its attachment
screws. 4
Apply rust protection (Mercasol) on the frame,
outside the motor flange as a protection of the
broken paint layers. 5
Continues on next page
352 Product manual - IRB 6640 Foundry Prime
3HAC040586-001 Revision: N
© Copyright 2011-2018 ABB. All rights reserved.
4 Repair
4.6.2 Replacing motor axis 2
Continued