ABB IRB 6640 Foundry Prime, Руководство по эксплуатации продукта

Страница: 145 / 496

Required equipment
Note Art. no. Spare part no. Equipment, etc.
For maintenance of balancing
device. 3HAC029054-001
Design 1 :
Maintenance parts,
shaft
Includes:
• bearings, o-rings and
seals (
Front bearing ).
For maintenance of balancing
device. 3HAC033411-001
Design 2 :
Maintenance parts,
shaft
Includes:
• bearings, o-rings and
seals (
Front bearing ).
For maintenance of balancing
device. 3HAC029288-001
Design 1 :
Maintenance parts,
cradle
Includes:
• bearing, o-ring and
sealing (
Rear bearing ).
For maintenance of balancing
device. 3HAC033413-001
Design 2 :
Maintenance parts,
cradle
Includes:
• bearing, o-ring and
sealing (
Rear bearing ).
Securing screw in the shaft. Securing screw
M16 x 180
Locking liquid must be used
when fitting the screw (Loctite
243)!
3HAC028920-001 Toolkit for mainten-
ance
Content is defined in section
Standard tools on page 465 .
3HAC15571-1 Standard toolkit
These procedures include
references to the tools re-
quired. Other tools and
procedures may be
required. See refer-
ences to these
procedures in the
step-by-step in-
structions below.
Check for dissonance
The check points are shown in the figure Inspection points, balancing device on
page 144 .
If dissonance is detected... Check for dissonance
from...
... perform maintenance according to given instructions
in Maintenance kit, bearings and seals. The replacement
of the bearing at the ear is also detailed in section
Re-
placement of spherical roller bearing, balancing device
on page 297
.
• bearing at the link ear
• bearings at the balan-
cing devices attach-
ments.
1
Art. no. for the kit and the documentation are specified
in section
Required equipment on page 145 .
Continues on next page
Product manual - IRB 6640 Foundry Prime 145
3HAC040586-001 Revision: N
© Copyright 2011-2018 ABB. All rights reserved.
3 Maintenance
3.3.7 Inspecting the balancing device
Continued