ABB IndustrialIT Compact HMI 800, Начало работы

Страница: 123 / 192

Section 7 Administration Other Maintenance
3BSE040587R4401 123
Other Maintenance
Check for and Install Latest Software Updates
It is important to check if there has come any software updates to the installed
Compact HMI 800 software. To make sure that the latest software versions are used
in the Compact HMI 800, this can be done by checking the document “Industrial IT
System Base SV 4.x System Software Versions” in ABB library, which lists the latest
releases of relevant software from ABB. The document includes a chapter
describing which software modules that are used by the Compact HMI 800 product.
The following link can be used:
http://abblibrary.abb.com/GLOBAL/SCOT/SCOT296.nsf/0/b4ff1a398ed0b65fc125
710f00789cd1/$FILE/3BSE037782R4001_J_en_IndustrialIT_System_800xA_SV_
4.x_System_Software_Versions.pdf
By comparing the versions of the software modules listed in the document for
Compact HMI 800, with the versions shown in the computer under Add Remove
Programs in the Control Panel, the versions can be verified.
If there is a newer version listed than what is installed, this software should be
downloaded and installed in each node where there is an older version of the
software installed. This is done in the following way:
1. Stop the Compact HMI 800 system services on the server (described in To Stop
and Start the System on page 123).
2. Download and install the software updates in all nodes connected to the server.
The document referenced above contains information from where the software
can be downloaded.
3. Start the Compact HMI 800 system (described in To Stop and Start the System
on page 123).
To Stop and Start the System
The Compact HMI server nodes contains a set of software services that are running
continuously in the background in the computer. These services are often referred to
as the system or Compact HMI 800 system. During some maintenance activities it is
necessary to stop and start these services. This is described below. When switching
on the power to a Compact HMI 800 server the system is automatically started.