Operating manual HVL 120-0.3
Area of application for the low voltage limiter
Protection of personnel
Protection of equipment
At all locations where dangers can occur from the
rail potential
On fully-conductive or semi-conductive components
which are not part of the operating electrical circuit
and which are located in the area of the overhead
line or current collector and which are not earthed
On parts which can become live in the event of a
fault
As overvoltage protection
On further high-current systems, telecommunications and other electrical systems which are at risk, or
which could be at risk, from the railway’s electrical power supply
3 TRANSPORT AND STORAGE
The low voltage limiter is supplied ex works, packed in a cardboard box. The accessories (fixing brackets,
fixing bolts and tension washers) are supplied separately from the low voltage limiter. Each consignment is
accompanied by final inspection record.
Scope of supply
Low voltage limiter
Fixing bracket for the low
voltage limiter
T-bracket for cable
connection
Bolts and tension
washers
Final inspection
record
1 x
1 x
1 x
4 x
1 x
Following delivery, each consignment must be checked for completeness and correctness (compare against
the order and delivery documents). In the case of incompleteness or deviations from the delivery documents,
the supplier and the carrier must be notified immediately.
The supplied goods must be examined for transport damage immediately on receipt. In the event of
transport damage, this must be reported immediately to the insurance agent, the carrier and the supplier,
and a damage report must be completed. Low voltage limiters which show any signs of damage must not be
installed in the system or be put into service.
The supplied equipment must be stored in a well-ventilated room and must be protected from dirt or
damage. The original transport package can be used for storage purposes.
1HC0023892 AA
EN
Page 3 / 12
