ABB DPA Upscale RI Series, Руководство пользователя

Страница: 124 / 133

Section-10
04-3006_S10_TDS_ABB_DPA_UPSCALE_RI_10-80kW_EN_150316.doc Page 7/16 ABB
Modifications reserved
10.5 OUTPUT CHARACTERISTICS
Module type unit UPScale M 10 UPScale M 20
Output rated apparent power (
cosphi 0.8)
kVA 10 20
Output rated active power (
cosphi 1.0)
KW 10 20
Output nominal current (In)
at 230VAC ph-N and cosphi 1.0
A 14.5 29
Output Rated Voltage V 3x380/220V or 3x400/230V or 3x415/240V
Output Voltage Stability %
Static: < +/- 1%
Dynamic (Step load 0%-100% or 100%-0%) < +/- 4%
Output Voltage Distortion %
With Linear Load < 1.5%
With Non-linear Load (EN62040-3:2001) < 3%
Output Frequency Hz 50 Hz or 60 Hz
Output Frequency Tolerance %
Synchronized with mains < +/- 2 %
(selectable for bypass operation)
or < +/- 4 %
Free running +/- 0.1 %
Efficiency AC-AC (at cosphi 1.0)
(tol/- 0.5% applies on all figures)
%
Load : 100% 75% 50% 25%
M20&M10 : 95.5 95.5 95 94.5
Bypass operation
At Nominal Input voltage of 3x400 V +/- 15%
or 190 V to 264 V ph-N
Permissible Unbalanced Load
(All 3 phases regulated independently)
% 100%
Phase Angle Tolerance
(With 100 % Unbalanced load)
° < 2
Overload Capability on Inverter %
125 % load 10 min.
150 % load 60 sec.
Output short capability on inverter (RMS) A 3.0xIn during 40 ms 2.25xIn during 40 ms
Output short capability on static bypass
(RMS)
A 10xIn during 20 ms
Static bypass transfer time:
inverter

bypass / bypass

inverter / in
eco-mode
ms <1 / <5 / <6
Crest Factor (Load supported) 3:1
10.5.1 GRAPH: AC
–
AC EFFICIENCY with Linier load @ cosphi 1
Efficiency up to 1 % higher with output PF cosphi 0.8
Details refer to paragraph 10.7 Environmental Characteristics
Linear Load (cosphi=1)
95.5 95.5
95
94.5
70
75
80
85
90
95
100
25 50 75 100
Load %
%
UPS Module 10/20kW