1
WARNING: Because of the possible danger to person(s) or
property from accidents which may result from the improper
use of products, it is important that correct procedures be
followed. Products must be used in accordance with the
engineering information specified in the catalog. Proper
installation, maintenance and operation procedures must
be observed. The instructions in the instruction manuals
must be followed. Inspections should be made as necessary
to assure safe operation under prevailing conditions. Proper
guards and other suitable safety devices or procedures as
may be desirable or as may be specified in safety codes
should be provided, and are neither provided by ABB nor
are the responsibility of ABB. This unit and its associated
equipment must be installed, adjusted and maintained by
qualified personnel who are familiar with the construction
and operation of all equipment in the system and the
potential hazards involved. When risk to persons or property
may be involved, a holding device must be an integral part
of the driven equipment beyond the speed reducer output
shaft.
WARNING: To ensure the drive is not unexpectedly
started, turn off and lock-out or tag power source before
proceeding. Failure to observe these precautions could
result in bodily injury.
WARNING: All products over 25 kg (55 lbs) are noted on the
shipping package. Proper lifting practices are required for
these products.
WARNING: Only qualified personnel familiar with hydraulic
and electrical installations, the construction and operation
of this equipment, and the hazards involved should install,
adjust, operate, and/or service it. Read and understand
this manual in its entirety before proceeding. Failure to
observe this precaution could result in severe bodily injury
or loss of life.
DODGE COOL LUBE 2 for Mounted Roller Bearings
Part Numbers 063485, 063486, 078327, 078328
These instructions must be read thoroughly before installation or operation. This instruction manual was accurate at the time of
printing. Please see
baldor.com
for updated instruction manuals.
Note! The manufacturer of these products, Baldor Electric Company, became ABB Motors and Mechanical Inc. on
March 1, 2018. Nameplates, Declaration of Conformity and other collateral material may contain the company name of
Baldor Electric Company and the brand names of Baldor-Dodge and Baldor-Reliance until such time as all materials have
been updated to reflect our new corporate identity.
System Specifications:
System
Part
Number
Motors Information
Approximate
Weights (lbs.)
063486
Single Phase—115/230 VAC
257
063485
Three Phase—230/460 VAC
257
078327
Three Phase—208-230/460 VAC
(Explosion Proof Motors)
257
078328
Three Phase—575 VAC (Canada)
257
Note: For Cool Lube 2 material details, please refer to cut
sheets.
Air to oil heat exchanger:
Thermal Transfer BOL-8-2
* Pump Relief valve setting:
150 psi
* Bearing Relief valve setting:
65 psi
Pump flow rate:
2 GPM
Flow meter range:
0.05 – 0.5 GPM
Oil supply line connection:
Two 1/4" NPT connections at
the flow meter outlets (female)
Oil return line connection:
Two 1” NPT connections
(female)
* Relief valves are preset at the factory, but are field
adjustable. If other settings are required, consult Dodge
Engineering
