ABB ABILITY™ SMART SENSOR BLUETOOTH® GATEWAY
DOCUMENT ID
REV.
DATE
LANG.
PAGE
9AKK107046A4620
L
August 2022
EN
18/29
© Copyright 2021 ABB. All rights reserved.
2.7
USB mobile dongle connection
Mobile network can be used with a specific USB dongle. An additional PoE injector is
needed for power supply (see
2.1 Prerequisites for installation
5
), supported USB
dongle and a SIM card are needed. Make sure to connect the gateway using an ethernet
cable to the port labelled as “
PoE
”, on the injector.
Figure 12
Mobile
network configuration
Insert the USB dongle with SIM card to USB port at the bottom of the gateway. PIN query
needs to be disabled from the SIM card.
From the Gateway Basic Page select:
-
Connection Priority:
3G/4G
(fw 1.4.3) /
Cellular
(fw 2.1.0)
-
USB Dongle Type: select correct
dongle type
used
-
Type the
Access Point Name
(APN) which the SIM carrier is using
-
Type the username and password for the APN if needed
Press
Apply
at the bottom of the screen.
Reboot the gateway by removing the power supply for a few seconds and then
reconnecting it.
The
Recommended Dongles
for industrial environments are the following:
-
MTCM2-L4G1-B03-KIT for Europe (LTE/CAT4)
-
MTCM-LNA3-B03-KIT for US/Canada (LTE/CAT1)
