CAP 501
Installation
Installation and Commissioning Manual
1MRS751270-MEN
ABB Automation
26
Granting the rights to a group
To grant the rights to start and stop the MicroSCADA service to the appropriate user
groups, first highlight the group in the upper list labeled ’No service start access’ and
click ’Add’. In the above example, the user group named ’Standard Corporate Users’ is
granted these rights.
Revoking the rights from a group
To revoke the rights from a user group, first highlight the group in the lower list
labeled ’Service start access’ and click ’Remove’. In the above example, the Windows
NT’s built-in user group named ’Users’ has been revoked these rights.
Note! This is a system-wide configuration affecting also all other products using the
same kernel software. For example, if you have SYS 500 installed on the computer
and you grant the rights to a group named ’Visitors’, intended for ordinary visitors, any
logged on member of that group is able to start and stop both CAP 501 and SYS 500
on the computer.
Saving the configuration
To save the configuration, click ’Close’ and confirm that by clicking ’OK’ on the dialog
box that will open, see Figure 12.
Figure 12.
Confirm to save the service access configuration.
Discarding changes to the configuration
To close the tool without saving the configuration, click ’Cancel’, in the
’MicroSCADA Service Access Manager’ dialog box. Provided that the configuration
has been changed, you must confirm the cancellation by clicking ’OK’ on the dialog
box that will open, see Figure 13, otherwise click ’Cancel’ to return to the manager.
Figure 13.
Confirm to discard the changes to the service access configuration.
