ABB CalMaster, Инструкция по эксплуатации

Страница: 4 / 12

2
2.1 Adapting the MagMaster
Transmitter
To enable a MagMaster system to be tested
by the CalMaster it is necessary to initially fit
a small adaptor board to the MagMaster
transmitter. This adaptor is provided with the
CalMaster Unit.
Once the adaptor is fitted to the MagMaster
transmitter, the CalMaster can be easily
connected to the transmitter for testing at any
time.
Extra adaptor kits are available from the
Company
The adaptor is supplied in the form of a PCB
fitted with connectors which fit into the sensor
connection terminals of the MagMaster
transmitter.
A connection socket is also provided, which
after termination with the sensor cable, is
connected with the plug on the adaptor PCB.
This provides a flexible means of inserting
connecting leads from the CalMaster, when
testing is required, and reconnecting the
MagMaster sensor wiring when the testing is
complete.
1 PREPARATION 2 INSTALLATION
1.1 Unpacking
Unpack and visually inspect the CalMaster.
Also packed with the CalMaster are:
a) CalMaster sensor test lead set.
b) CalMaster to MagMaster communication
lead set (includes three test probes for
frequency measurement).
c) Adaptor PCBs incorporating a plug to
accept the socket in item d) below.
d) Socket which fits into item c) above.
The socket is first terminated with the
sensor cable.
e) One lead to interconnect the CalMaster
and a computer (Serial Data Connection).
f) Screwdriver for terminals.
g) Two 'CalMaster Software' Disks.
h) This Instruction Manual.
i) Mains operated battery charger
j) Lead for charging battery from12 Volts.
Save packing materials for any re-shipment,
or to support any claim of shipment damage.
All damage claims are made against the
carrier and are the responsibility of the
customer.
Fig. 2.1 Adaptor Board for Transmitter
Adaptor PCB fitted with plug,
and connectors for direct
connection to terminals
Plug
Socket for termination
of sensor cable