Operating Instructions
Busch-Wächter
®
Operation
Operating Instructions | 1473-1-8136
— 17 —
8.4
Programming the device
8.4.1
Programming the device
For programming, perform the following steps:
Fig. 16: Selector switch of the receiver
1. Set the selector switch of receiver 6701 on "P", LED flashes green.
Fig. 17: Programming button
2. Press the programming button on receiver 6701 (2), the LED (1) lights permanently green.
Fig. 18: Set the selector switch on “P”.
3. Set the selector switch of the Busch-Watchdog on "P", the status LED lights up for approx. 10 seconds (with a
slight delay).
4. The devices are being programmed to each other.
5. After successful programming, the LED starts to flash green again. If programming is not successful (the LED
continues to light up), reset the selector switch on the Busch-Watchdog to “P” and repeat the procedure.
6. Set the operating mode of
receiver 6701
on "R" or "S" or program additional Watchdogs.
7. Select the operating mode of the
Busch-Watchdog
on “ES” or “GS”.
P
R
S
E
A
E
1+2
T
B
GS
ES
P
