•
Make sure that the load capacity of the grid is in accordance with the EVSE.
•
Earth the EVSE correctly. Refer to section
•
Make sure that the wiring inside the EVSE is protected from damage and cannot
get trapped when you open or close the cabinet.
•
Make sure that water cannot enter the cabinet.
•
Protect the EVSE with safety devices and measures that the local rules specify.
•
If it is necessary to remove safety devices, immediately install the safety devices
after the work.
•
Put on the correct personal protective equipment. Refer to section
.
2.7
Safety instructions during transport
Preliminary requirements
•
Installation engineer
•
•
Make sure that the hoisting equipment or forklift truck can lift the EVSE safely.
Take into account the mass and the center of gravity of the EVSE.
•
Obey the safety instructions that apply to the hoisting equipment or the forklift
truck.
•
Put on the correct personal protective equipment. Refer to section
.
2.8
Safety instructions for earthing
Preliminary requirements
•
•
Make sure that the EVSE is connected to a grounded, metal, permanent wiring
system, or an equipment-grounding conductor must be run with the circuit
conductors and connected to the equipment grounding terminal or lead on the
product.
•
Make sure that the connections to the EVSE comply with all applicable local
rules.
2.9
Safety instructions for use
•
In these situations, do not use the EVSE and immediately contact the
manufacturer:
•
An enclosure has damage.
•
An EV charge cable or connector has damage.
•
Lightning struck the EVSE.
•
There was an accident or a fire at or near the EVSE.
•
Water has entered the EVSE.
Safety
16
9AKK108466A3703-EN | 001
