ABB ACS880 Series, Руководство по прошивке

Страница: 307 / 764

Def / Type
FbEq 16b / 32b Description Name / Range /
Selection No.
0.00 rpm / real32 Defines the low limit for critical speed range 2.
Note: This value must be less than or equal to the value
of
22.55 Critical speed 2 high .
Critical speed 2 low 22.54
- / - Low limit for critical speed 2. For scaling, see parameter
46.1 .
-30000.00 ...
30000.00 rpm
0.00 rpm / real32 Defines the high limit for critical speed range 2.
Note: This value must be greater than or equal to the
value of
22.54 Critical speed 2 low .
Critical speed 2 high 22.55
- / - High limit for critical speed 2. For scaling, see
parameter
46.1 .
-30000.00 ...
30000.00 rpm
0.00 rpm / real32 Defines the low limit for critical speed range 3.
Note: This value must be less than or equal to the value
of
22.57 Critical speed 3 high .
Critical speed 3 low 22.56
- / - Low limit for critical speed 3. For scaling, see parameter
46.1 .
-30000.00 ...
30000.00 rpm
0.00 rpm / real32 Defines the high limit for critical speed range 3.
Note: This value must be greater than or equal to the
value of
22.56 Critical speed 3 low .
Critical speed 3 high 22.57
- / - High limit for critical speed 3. For scaling, see
parameter
46.1 .
-30000.00 ...
30000.00 rpm
Disabled / uint16 Activates and selects the mode of the motor
potentiometer.
See section
Motor potentiometer (page 112) .
Motor
potentiometer
function 22.71
0 Motor potentiometer is disabled and its value set to 0. Disabled
1 When enabled, the motor potentiometer first adopts
the value defined by parameter
22.72 Motor
potentiometer initial value .
When the drive is running, the value can be adjusted
from the up and down sources defined by parameters
22.73 Motor potentiometer up source and 22.74 Motor
potentiometer down source .
A stop or a power cycle will reset the motor
potentiometer to the initial value (
22.72 ).
Enabled (init at
stop/power-up)
2 As Enabled (init at stop/power-up) , but the motor
potentiometer value is retained over a stop or a power
cycle.
Enabled (resume
always)
0.00 / real32 Defines an initial value (starting point) for the motor
potentiometer. See the selections of parameter
22.71
Motor potentiometer function .
Motor
potentiometer initial
value 22.72
1 = 1 / 100 = 1 Initial value for motor potentiometer. -32768.00 ...
32767.00
Parameters 307