ABB ACS280, Руководство по прошивке, Страница: 347 / 430

Fault tracing 347
Other - Contact your local ABB representative,
quoting the auxiliary code.
73B0 Emergency ramp
failed
Emergency stop did not
finish within expected time.
Check the settings of parameters
31.32 Emergency ramp supervision
and
31.33 Emergency ramp
supervision delay
.
Check the predefined ramp times
(
23.11
…
23.15
for mode Off1,
23.23
for
mode Off3).
8001 ULC underload fault User load curve: Signal has
been too long under the
underload curve.
See parameter
37.04 ULC underload
actions .
8002 ULC overload fault User load curve: Signal has
been too long over the
overload curve.
See parameter
37.03 ULC overload
actions
.
80A0 AI supervision
Programmable fault:
12.03 AI supervision
function
An analog signal is outside
the limits specified for the
analog input.
Check signal level at the analog input.
Check the wiring connected to the
input.
Check the minimum and maximum
limits of the input in parameter group
12 Standard AI .
80B0 Signal supervision
(Editable message
text)
Programmable fault:
32.06 Supervision 1
action
Fault generated by the signal
supervision 1 function.
Check the source of the fault
(parameter
32.07 Supervision 1 signal
).
80B1 Signal supervision
(Editable message
text)
Programmable fault:
32.16 Supervision 2
action
Fault generated by the signal
supervision 2 function.
Check the source of the fault
(parameter
32.17 Supervision 2 signal
).
80B2 Signal supervision
(Editable message
text)
Programmable fault:
32.26 Supervision 3
action
Fault generated by the signal
supervision 3 function.
Check the source of the fault
(parameter 32.27 Supervision 3 signal ).
80B3 Signal supervision
(Editable message
text)
Programmable fault:
32.36 Supervision 4
action
Fault generated by the signal
supervision 4 function.
Check the source of the fault
(parameter
32.37 Supervision 4 signal
).
80B4 Signal supervision
(Editable message
text)
Programmable fault:
32.46 Supervision 5
action
Fault generated by the signal
supervision 5 function.
Check the source of the fault
(parameter
32.47 Supervision 5 signal
).
Code
(hex) Fault / Aux. code
Cause What to do