13
Irrigation specific home screens
Three home screen options that been configured specifically for irrigation. The primary home
screen includes the exclusive total flow, acre foot calculation.
How to start up the drive using First start assistant with the irrigation specific software
Note:
Automatic selection of supply voltage is not supported in the ACQ580 ULH irrigation drives
(ACQ580-3P). You must select the supply voltage manually using parameter 95.01 Supply Voltage.
Follow the instructions below.
Primary home screen
Secondary home screen
Tertiary home screen
Safety
Do not start-up the drive unless you are a qualified electrician.
Read and obey the instructions in chapter
Safety instructions
at the beginning of the
Hardware manual
of
the drive. Ignoring the instructions can cause physical injury or death, or damage to the equipment.
Check the installation. See chapter
Installation checklist
in the
Hardware manual
of the drive.
Make sure there is no active start on (
DI1
in factory settings, that is, default configuration). The drive
will start up automatically at power-up if the external run command is on and drive is in the external
control mode.
Check that the starting of the motor does not cause any danger.
De-couple the driven machine
if:
• there is a risk of damage in case of an incorrect direction of rotation, or
• a
Normal
ID run is required during the drive start-up, when the load torque is higher than 20% or the
machinery is not able to withstand the nominal torque transient during the ID run.
Hints on using the assistant control panel
The two commands at the bottom of the display (
Options
and
Menu
in the figure on the right), show the functions of the two softkeys
and
located below the display.
The commands assigned to the softkeys vary depending on the
context.
Use keys , , and to move the cursor and/or change
values depending on the active view.
Key shows a context-sensitive help page.
For more information, see
ACx-AP-x assistant control panels user’s
manual
?
