bdi
Wind
for Tornado™, BDI2000 (MPC8xx/MPC5xx)
User Manual
52
© Copyright 1997-2007 by ABATRON AG Switzerland
V 1.38
Appendices
A BDI2000 Setup/Update
First make sure that the BDI is properly connected (see Chapter 2.1 to 2.4).
To avoid data line conflicts, the BDI2000 must be disconnected from the target system while
programming the logic for an other target CPU (see Chapter 2.1.1).
dialog box «BDI2000 Update/Setup»
Before you can use the BDI2000 together with the Tornado development environment, you must store
the initial configuration parameters in the BDI2000 flash memory. The following options allow you to
do this:
Channel
Select the communication port where the BDI2000 is connected during
this setup session.
Baudrate
Select the baudrate used to communicate with the BDI2000 loader during
this setup session.
Connect
Click on this button to establish a connection with the BDI2000 loader.
Once connected, the BDI2000 remains in loader mode until it is restarted
or this dialog box is closed.
Current
Press this button to read back the current loaded BDI2000 software and
logic versions. The current loader, firmware and logic version will be
displayed.
Update
This button is only active if there is a newer firmware or logic version
present in the execution directory of the bdiWind setup software. Press
this button to write the new firmware and/or logic into the BDI2000 flash
memory / programmable logic.
!
