bdi
Access
JTAG interface library, BDI1000 (ARM7/9/9E)
Installation Manual
20
© Copyright 1992-2008 by ABATRON AG
V 1.02
B Maintenance
The BDI needs no special maintenance. Clean the housing with a mild detergent only. Solvents such
as gasoline may damage it.
If the BDI is connected correctly and it is still not responding, then the built in fuse might be damaged
(in cases where the device was used with wrong supply voltage or wrong polarity). To exchange the
fuse or to perform special initialization, please proceed according to the following steps:
Observe precautions for handling (Electrostatic sensitive device)
Unplug the cables before opening the cover.
Use exact fuse replacement (Microfuse MSF 1.6 AF).
!
1
2
3
BDI1000
1.1 Unplug the cables
2.1 Remove the two plastic caps that cover the screws on target front side
2.2 Remove the two screws that hold the front panel
3.1 While holding the casing, remove the front panel and the blue elastig sealing
(e.g. with a small knife)
front panel
elastic sealing
casing
TARGET A TARGET B
BD
I
TRGT
MODE
