If the bath has the Autofill option, the bathing cycle can be completed
without having to worry about overfilling. Simply press a button and the
bath will fill automatically.
Filling the Bath
The autofill has two buttons for operation and one spout, the red
button for hot water and the blue button for cold.
Press the red or blue fill button situated on the rim of the bath.
Fig 1.
The autofill buttons will glow on standby, and flash during filling.
This will fill the bath to a pre-set fill level.
Fig 2.
Once the pre-set fill level is reached the water will automatically stop. If
at any time you wish to stop the autofill process simply re-press the
button.
The system allows you one additional top up past the pre-set fill level.
Press the red or blue fill button; this will deliver water for a maximum
of 30 seconds. Once again the flow can be stopped by re-pressing the
button.
Temperature Adjustment
The red fill button supplies hot water at a pre-set temperature (usually
43
°
C). To reduce the temperature of the bath water during the autofill
process, press the blue (cold) button.
Fig 1.
When the bath filling is complete check the water temperature before
the bather enters, or for ‘walk-in baths’ the user can stop, start or
modify flow temperature as required throughout the autofill process.
Note – Once the maximum fill level has been reached, water must be
drained before any more water can be added.
Fig 2.
If you are unable to top up, drain water to below the pre-set
fill level.
Tamperproof Lock Out - Fig 3.
The autofill has a lock out to prevent wastage of water and tampering.
To Lock
Press and hold down both hot and cold buttons for 10 seconds. The red
and blue LED lights will go out, confirming water lock out.
To Unlock
Press and hold down both buttons again for 10 seconds. The buttons
will turn red and blue confirming unlock.
For optimum performance it is recommended that the bath is cleaned
regularly.
AUTOFILL OPTION
Fig 1
Fig 2
Fig 3
Gemini 2000 User Manual v1.3
13
