AAton XTRprod, Руководство пользователя

Страница: 24 / 109

checking that the sharp focus of a lens matches the measured distan-
ce on its barrel. If it does not, then you need to make an adjustment
of the viewing screen focus.
To proceed, you must first unscrew and remove the circular cap lo-
cated on behind the camera body Run/Test switch.Inside the access
hole, inser a 2mm Allen wrench and screw or unscrew it. Replace
the circular cap. Use a collimator to check that you have reached the
sharpest focus of the viewing screen image. If the image is not yet
sharp ennough, proceed again.
2.2.10 Aatonite Illumination
The XTRprod features illuminated viewing screen markings referred
to as Aatonite. The level of illumination is adjustable by the user via
the Jog wheel, which is located to the right of the motor. To operate
Aatonite, power the body and switch the run/test switch to test posi-
tion and off again to turn on the camera electronics. Look through
the viewfinder and rotate the jog to set the desired level of illumina-
tion. The markings will remain illuminated for a full 2 minutes after
the camera is set in the off position. The illumination level set in
test position will be memorized and recalled once the camera is run.
The illumination level can also be readjusted while the camera is
24
Warning !
Each time you're touching the
mirror, the viewing screen, or
anything inside the lens port,
disconnect the battery. You
will therefore avoid any risk of
seriously damaging your came-
ra.