AAT MEGA II CLEANER, Руководство по эксплуатации

Страница: 66 / 92

58 Rev. 2.0 10/15/2005 Mega II Operating Manual
bung connection. If a smaller drum is to be used, the pickup pipe
must be cut to fit whatever size drum is being used.
B.3.2 CHANGE CYCLE SETUP 1-5
This selection allows the user to enter settings of the various modes of the
PreWash cycle. i.e. setpoint and time values. All cycle setups have pre-defined
values entered for functional testing at the factory. This manual provides
guidelines for setting up the cycle, but testing should be performed to verify the
cleaning performance.
Refer to the following table for the key press sequence to change the cycle setup:
Key Selection OP Display
From Main Menu, select Change Cycle Setup 1-5
Select/Arrow/Clear
Press “
SELECT
” Key
or use arrow keys to
select cycles 2-5
Change Cycle #1
Select/Arrow/Clear
Press “
ENTER
” Key
and wait 2-3 sec.
Prewash Enable = ___
New Settings (0,1) = ___
Range 0-1
0= Disable, Off
1= Enable, On
Arrow keys to adjust
(If 0 is selected, the program
defaults to the final Wash cycle
Ultrasonics- enable/disable ,
bypassing the PreWash menu
settings. )
(If 1 is selected, the PreWash
program is enabled.)
Press “
ENTER
” Key
and wait 2-3 sec.
Prewash Time = ____._ sec
New Setting = ____._ (S)
Range 0-999.9 seconds
Arrow keys to adjust
Press “
ENTER
” Key
and wait 2-3 sec.
U.S.(0) or Rec. (1) = ___
New Setting (0,1) = ___
Range 0-1
0 = U.S. = Ultrasonic
1=Rec= Recirculate (air)
Arrow keys to adjust (This selects
the type of agitation).
Press “
ENTER
” Key
and wait 2-3 sec.
Prewash Dry (time) = ____._sec
New Setting = ____._ (S)
(HVD option required for heat)
Range of 0-999.9 seconds
Arrow keys to adjust