Integrated Access Controller –
Installation manual
12
AAT SYSTEMY BEZPIECZEŃSTWA Sp. z o.o.
All rights reserved.
5.3 Setting the control parameters and identification mode of doors
After entering the programming mode enter the code
21
, then:
•
value from
00
to
99
seconds (default
-
3 sec.)
This is the time by which, when a valid card or code is used the door will be
unlocked.
After entering the programming mode enter the code identification mode:
•
221
-
Card only
•
222
-
Card + PIN
•
223
-
PIN only
•
224
-
Card or PIN
6. User Management
In standalone mode can be added up to 2000 users. Each user must be assigned
with ID from 0000 to 1999 in the programming process and then assigned ac-
cess card number read by the reader. This allows the system administrator can
remove the user from the database without the need a card (which can be erg.
lost), knowing only the user's ID code. Cards added in standalone mode have full
access to the passage (24 hours a day, 7 days a week). In contrast to the added
cards from the program, which can be assigned to a limited level of access. To
avoid the need for dual record cards and disadvantages related to the two data-
bases cards in practice, it is recommended to use only one controller mode
-
standalone or network. Before adding users, it is recommended that the admin-
istrator has created a list of users with assigned four
-
digit ID code. This makes it
easier to add new users later, and in particular the removal of lost cards.
6.1 Adding a package of cards
After entering the programming mode enter the code
31
, then:
•
Enter the ID of the first user of the package
•
Close the cards one of the other to the reader
After read each card reader will generate a single beep.
•
Repeat the operation for the next card
•
After loading press #
Read the card will be credited automatically generated ID numbers. The process
is best preceded by the preparation of a list of IDs, user names and card num-
bers.
6.2 Adding a single card
After entering the programming mode enter the code
32
, then:
•
Enter the user ID from the list
•
Close the cards one of the other to the reader
After you read the card reader will generate a single beep and automatically ex-
its the programming mode.
6.3 Adding a package of cards with PIN codes (6 digits)
After entering the programming mode enter the code
33
, then:
•
Enter the ID of the first user of the package
•
Close the cards one of the other to the reader
•
Enter the PIN
-
> enter the PIN again
•
Repeat the operation for subsequent reading cards with PIN codes
After each added card reader generate a single beep. Read the card will be cred-
ited automatically generated ID numbers.
•
After loading press #
