Aastra OpenCom 100 series, Руководство по монтажу и пусконаладке

Страница: 92 / 256

Configuration
90
Note
If you are operating an PBX cascade, new system software is automatically trans-
ferred to the slave system from the master system.
For further information, refer to the online help documentation under the item
System: Firmware .
Resetting the System Data
You can restore the factory settings of the OpenCom 100 in the Configurator. If this is
not possible, refer to the next section entitled
Basic Hardware Settings Switch .
Please note: If this is done, all individual settings and the user data are then
lost. For this reason, you should back up your configuration reg-
ularly, the best time to do so being after every change. For de-
tails, refer to the chapter entitled Saving and Loading the Con-
figuration starting on page 85 and to the Web console online
help.
Proceed as follows:
1. In the Configurator, call up the System : Restart menu.
2. Click on Restart with Defaults .
3. Confirm this by pressing “OK” when the query dialogue box opens.
Basic Hardware Settings Switch
The OpenCom 100 configuration can also be returned to the factory settings by
means of the basic hardware settings switch.
Please note: If the factory settings are restored, all customer settings and user
data will be lost.
To restore the OpenCom 100 basic settings, proceed as follows:
1. Switch off the OpenCom 100 by disconnecting the power plug and the plug-in
power supply of the basic module (OpenCom 130).
2. Remove the cover.