Configuration Examples
98
The OpenCom 100 in a LAN with an IP-enabled server
Dynamic Address Assignment for Specific Devices
In addition to the static address assignment, you can also use dynamic address
assignment if you limit dynamic assignment to specific devices. You can use this e.g.
to easily configure VoIP devices because you do not need to assign a fixed IP address
during setup.
1.
Call up the
Network
:
DHCP
page. Click
Change
.
2.
In the
Status
selection, change to the
Dynamic address assignment
or to the
Dynamic and static address assignment
setting.
3.
In the
Devices
selection, change to the
with configured MAC only
setting.
For SIP system telephones (Aastra 673xi and Aastra 675xi), it is also possible to
omit the configuration of the MAC address (see Aastra 673xi/675xi DHCP starting
on page 129). In the
Devices
selection, change to the
with configured MAC only
and SIP system devices
setting. Please note, that you also need to exclude from
the configuration of an external DHCP server all MAC addresses starting with
00:08:5D.
4.
Confirm with
Apply
.
By activating the limitation to specific devices, only known devices can get a DHCP
answer. For this, the IP address is taken from the address range used for dynamic
address allocation. If you setup a new VoIP device, it is sufficient to enter only the MAC
address.
OpenCom
S
0
Net
PC 2
Net
S
0
int
Server
(DHCP, RAS,
int. DNS,
Internet)
S
0
Net
ISP
(DNS)
S
0
Ext.
PC
S
0
PC 1
Net
Hub
Содержание OpenCom 100 series
