Installation and Setup
41-001158-05 Rev 03 – 04.2012
9
Inline Power Not Provided
If your network does not provide 802.3af compliant in-line power, you need to install the PoE inline power injector (optional
accessory).
1.
On the top of your phone, connect the Ethernet cable (provided with your phone) into the network port marked
with
LAN.
2.
On the PoE power injector, plug the other end of the Ethernet cable into the network jack marked as indicated in the
illustration below.
3.
On the PoE power supply, connect an additional Ethernet cable into the network port as indicated in the illustration below.
4.
Plug the other end of the Ethernet Cable into the network jack on the wall.
5.
Plug the PoE power injector into a power outlet.
Note:
You should connect the power supply to a surge protector or power bar. All Ethernet cables used must be minimum
category 5/5e straight-through cables, such as the cable provided with your phone.
PoE
Power injector
(if Inline power is
not provided)
Power Outlet
To Network
Jack
To Phone
Ethernet
Cables
Network Jack
To PoE