Installation of the terminals in the range
55
The standard connection of the terminals is as follows:
A pair is required to connect the phones. We recommend using a shielded cable that is
grounded on the splitter side.
The line is always wired to the 2 middle contacts of the phone's RJ11 connector.
If your configuration is different, cords are available to connect the phones to the telephone
network:
- Standard wall socket (French type): HK1040B (kit of 10 cords)
- RJ45 wall socket (with 7 and 8 wired): HK1041A (kit of 10 cords)
Note:
The distance required is 1000 m in 4/10 and 1800 m in 6/10.
Mounting the phone
Desktop phone
The phone is equipped with two fixed feet under the phone so that it can be placed on a
desk. Four tilting angles are available to customise the position of the phone.
Insert each foot into one the notches on the phone base. The upper part of the housing has
three pairs of notches. Each foot is inserted into two pairs of notches (1 and 2 or 2 and 3)
so that different tilt angles can be phone. The feet can also be reversed to obtain two more
angles.
For a greater angle, use the second and third notches from above. For a smaller angle, use
the first and second notches. Insert the foot until it snaps in.
