Supplementary features
45
eu
d-
0840
/2.
1 —
I7
.7
— 10
.20
0
8
■
Personal call routing
You wan to specify which of your terminals shall ring when you receive a call.
If your system administrator has set up a phone number with several terminals for you as well as
the 5 call routings, you can specify which of your terminals shall signal a call by using the per-
sonal call routing. Your system administrator can set up up to 5 call routings. You can only
answer a call on terminals where the call is signalled. Contact your system administrator for
more information.
You can activate a call routing for all terminals. If you have not configured a call routing, the fac-
tory setting (all terminals are ringing) is used as standard.
You can execute this function only with a */# procedure (see "User’s Guide */# Procedures").
■
Ring Alone
You want to specify which of your terminals shall ring acoustically when you receive a call.
When your system administrator has set up a phone number with several terminals, you can
define on which terminal a call shall acoustically be signalled using Ring Alone.
When you have activated Ring alone on a terminal, the acoustic ringing tone is deactivated for
all other terminals (
). An incoming call is signalled in the display of all terminals. You can
answer the call on each of your terminals.
This function must be stored under a function key (see Chapter
"Configuring Keys"
, page
56
).
Note:
When you have activated ring alone but deactivated the personal call routing for a terminal in parallel, an
incoming call is not acoustically but only visually signalled.
In the idle state:
Press the function key for
<Ring Alone>
.
➯
Ring Alone is activated/deactivated.
