4
Model 470 User Guide
Installation
Installation
Your Model 470 telephone can be
installed on a desk or mounted on
the wall. To use the phone’s Call
Waiting and Caller Identification
capabilities, contact your local
Service Provider for subscription
details. Your Service Provider may
call these services by different
names.
1. Connect the handset cord
Turn the telephone over and locate
the handset jack marked
j
.
Insert one end of handset cord into
the jack until it clicks into place.
Then route the handset cord
through the groove as shown in the
illustration below.
Attach the handset to the other end
of the handset cord.
2. Attach the stand
If you plan to mount the phone on
the wall, you do not need to attach
the stand; skip this step.
If you plan
to use the phone on a desk, attach
the stand by inserting the tabs on
the stand (marked with
o
o
o
o
) into the
slots on the bottom of the telephone
(A). For a higher viewing angle, use
the slots marked
n
. For a lower
viewing angle, use the slots marked
m
. Then slide the stand towards
the phone until it snaps into place
(B).
3. Connect the cords
If you attached the stand to install
the phone on a desk,
route both the
phone cord and power adapter cord
through the opening in the stand.
Insert the phone cord into the slot
on the back of the telephone marked
l
until it clicks into place. Insert
the power cord into the power jack
marked
k
.
4. Press the cords into grooves
Press the cords into two of the
grooves provided on the bottom of
the stand. This will allow the stand
to sit flat on a desk surface.
5. Install the phone
If you have installed the stand and
are using the phone on a desk:
Simply turn the telephone over so it
rests on the stand. Connect the
phone cord to a phone jack and plug
the power adapter into a power
outlet.
Note:
You should connect the
power adaptor to a surge pro-
tector or power bar.
A
B
2
1
Handset cord
Handset
Handset groove
3
4
Power Adaptor
Phone cord
Stand
Line grooves
Handset cord jack
Headset cord jack
Phone cord jack