Page 10 American Access Systems / Security Brands, Inc.
Program Relay “A” Access Codes -- Sub-Mode 1
To program Relay “A” access codes, use the following steps:
• Enter 1 2 5 1 (or, if the factory MASTER CODE has been changed, enter the programmed MASTER CODE)
• Unit will sound a GOOD TONE
• Enter the numeral 1
• Unit will sound a GOOD TONE
• Enter a four-digit code combination other than the MASTER CODE (for example enter 4 3 2 1)
• If you receive an ERROR TONE after an entry it means that particular code is already assigned and you must
select another code
• If you make a mistake during entry, press the star (*) key, then re-enter the code.
• When a new code is accepted the unit will sound a GOOD TONE
• Continue to enter codes until you are finished
• When you are done, press the pound (#) key to exit the programming mode
NOTES: You will automatically be exited from the programming mode IF:
• The memory reaches capacity
• The memory is full, you will not be able to enter Sub-Mode 1 and you will receive an ERROR TONE if you try to
enter this Sub-Mode.
• To enter new codes if the memory is full, you must first delete codes some of the codes already in memory.
• Contact AAS if there seems to be a problem programming additional codes.
