Aarrow Apex, Руководство по эксплуатации и установке

Страница: 8 / 32

FIREBOX LININGS & THROAT
PLATE
The Apex Multifuel stoves firebox has reflective
liners to the sides and rear and a specially shaped
throat plate which sits on the liners. If these are not
in place please refer to page 16 to install these.
MULTIFUEL GRATE
The Aarrow Multifuel grate comprises of a series of
reciprocating cast iron bars seated on a pivoted
"comb". These should come fitted in your stove, if
not please refer to page 17 for fitting and operation
and also operating instructions on fuels for correct
settings of the grate.
AIR INLET CONTROLS
Apex multifuel stoves have two air inlets:
•The air wash system (so called because its
pre-heated high speed air washes across the inner
face of the door glass, keeping it clear), which
provides over draught, and
•The lower set of holes; the primary air inlet
providing under draught to the base of the fire
chamber through controls on the bottom of the
stove door.
PRIMARY AIR FOR MULTIFUEL
Air enters the appliance through the control on the
bottom of the fire door. The Aarrow Apex has a
single control knob which slides left to right.
Sliding the knob to the right will increase the
amount of air intake to the stove. To decrease push
knob to the left.
AARROW AIRWASH SYSTEM
The air wash has an internal sliding plate with slots,
housed in a cover plate, and is located above the fire
door. Sliding the control knob to the right as far as it
will go achieves the fully open position. Sliding it to
the left will shut off the air inlet slots As shown in
figures 1 and 2.
Fig. 1 Fully Closed Fig. 2 Fully Open
Even when all the slots are completely shut a
"bleed" of secondary air will be maintained
ensuring that inflammable gases are burnt off.
DISASSEMBLE AIRWASH
The Apex air wash may be disassembled for
cleaning or adjustment. To achieve this, the
following procedure should be followed:
This should only be carried out when the fire is cold
and unlit.
•Support Air Wash cover with one hand.
•Move cover up by smartly tapping the bottom with
a hammer. (Fig. 3)
Remove assembly from appliance.
•Clean and/or adjust.
•Refit using reverse procedure.
Fig. 3
8 Apex Multifuel Stoves
OPERATING INSTRUCTIONS