HW © 2015 Aaronia AG, DE-54597 Strickscheid
9
Manual MagnoTRACKER
MagnoTRACKER
4.1.
Control dials x1 to x1000 and Big control dial (0-15)
With the control dials the center frequency can be adjusted. Turn left for high frequency. The
more you turn right, the lower the frequency will get (tuning more finely with Big control dial in
the middle). For better understanding of the functionality, it is recommended to connect the
antenna to a spectrum analyzer and start a quick sweep with 9 kHz to 1MHz Span. Then you
will understand more clear on the operation modes of the antenna.
4.2.
Slide switches 1 to 4
With 2 Slide switches (1-4) the antenna can be adjusted to 4 different internal antennas (here
both Slide switches must always have the same position). The higher frequency you want,
the smaller setting you should choose. (1= high frequency, 4= low frequency, see page 11).
5.
Application Example
The MagnoTRACKER is a magnetic field antenna. The antenna is not suitable for
measurements of electric fields.
One of the typical application areas of the MagnoTRACKER is the detection of disturbing
signals (e.g. on telecom wires like DSL, ADSL, etc.), which are generated e.g. from switching
power supplies. Further typical application areas would be amateur radio, reception from
submarine communication, maritime radio, Sferics and RFID appliance.
The possibility to fine-adjust the antenna offers a directivity/resolution of up to 1 degree or
even better.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
