AAON MODGAS-XWR2, Техническое руководство

Страница: 14 / 38

COMMUNICATING WIRING
MODGAS-XWR2 Technical Guide
14
2V2IGN2S - Communicating Wiring
Figure 11: 2 Modulating Valves, 2 Ignitors, 2 Stage Communicating Wiring Diagram
2 Modulating Valves, 2 Ignitors,
2 Stages (2V2IGN2S) - Communicating
Wiring
This configuration operates as Stand-Alone ( Figure 3, page 6 ) or
communicating with an AAON Unit Controller (
Figure 11, below
).
This configuration is used to control two modulating gas valves (one
on each header), in which the first valve is modulating stage 1 (valve
1 header) and the second valve is modulating stage 2 (valve 2 header).
The first valve is attached to Heat Relay 1 and the second valve is at -
tached to Heat Relay 2.
For VCM-X Controllers, use an I
2
C Cable connecting to the appropriate
I
2
C port on the controller.
For all other controllers, use an E-BUS cable connecting to an E-BUS
port on the controller.
NOTE: Up to 2 additional fixed heat stages can be used by using
Heat Relays 3 & 4 below. If additional fixed stages are
required, these should be configured and wired to the
AAON Unit Controller’s relays.