2
Thank you very much for purchasing your new ULTRA X moisture tester.
Please read the following instructions carefully.
[Geben Sie ein Zitat aus dem Dokument oder die Zusammenfassung eines interessanten
Punktes ein. Sie können das Textfeld an einer beliebigen Stelle im Dokument positionieren.
Verwenden Sie die Registerkarte 'Textfeldtools', wenn Sie das Format des Textfelds
'Textzitat' ändern möchten.]
ULTRA X instruments normally work for many years. Should it be necessary however
to send the device to our service department, please use the
original packing
or ask
us for a new one.
The
warranty
requires that the devices are handled according to their sensitiveness.
The devices have a built-in mg-balance and may not be exposed to strong shocks.
A broken weighing cell does not come under the warranty.
Safety advices
Transport the instrument only in the upright position
Do not expose the instrument to heavy shocks
Operate the instrument always horizontally and on a vibration-free surface
Parts of sample material shall not fall between the pan holder and the housing, that
will hinder the balance.
Never touch the hot radiator, there is a risk of injury!
Pull out the mains plug before maintaining the instrument
Maintenance should only be done by experts in electric equipment
Take special care when drying inflammable sample materials
Use only accessories in ULTRA X quality
Dispatch the instrument only in the original packing
1. Starting
1.1.
Place the instrument on a horizontal, firm and vibration-free surface.
1.2.
(Not for UX 2081 types)
Set the radiator’s height with the calibration stick to 7 – 8 cm between the
reflector’s edge and the top surface of the housing. Loosen the screw at
the reflector holder and move the reflector up into the correct position.
1.3.
Swing back the radiator and place a drying pan onto the pan holder by
using the special steel tong (UX 2081 types come along with two tongs)
1.4.
Check the local mains voltage to the instrument’s voltage shown on the
identification plate on the backside of the instrument.
1.5.
Connect the instrument to the mains.
1.6.
Start the instrument with the Standby button.
