A&E Systems 5000, Инструкция по замене

Страница: 2 / 6

2
NOTE NOTE
NOTE NOTE NOTE: Some 5000 and 7000 Model Awning torsion
assemblies can not be pinned. If you have this type, the
torsion spring must be unwound before the awning can
be removed from the coach. Follow the instructions in
Section C, Steps 1 and 2. b. To keep the 5000 or 7000 Model Awning from unwind-
ing, it must be pinned. See FIGS. 3 & 3A.
C. C.
C. C.
C. UNWINDING A UNWINDING A
UNWINDING A UNWINDING A
UNWINDING A T T
T T
TORSION ASSEMBL ORSION ASSEMBL
ORSION ASSEMBL ORSION ASSEMBL
ORSION ASSEMBLY SPRING Y SPRING
Y SPRING Y SPRING
Y SPRING
NOTE NOTE NOTE NOTE NOTE: If the awning is installed on a coach, complete the
following steps on a step ladder, with the awning fabric
unrolled two feet from the awning rail.
1. Clamp a Vise Grip® tightly on the top casting. Remove
the 1/4-20 hex head machine screw from the top
casting. See FIG. 4.
W W
W W
WARNING ARNING
ARNING ARNING
ARNING
Severe injuries can result from the rapid spin-off of Severe injuries can result from the rapid spin-off of Severe injuries can result from the rapid spin-off of Severe injuries can result from the rapid spin-off of Severe injuries can result from the rapid spin-off of
the top casting. Use Vise Grips
the top casting. Use Vise Grips the top casting. Use Vise Grips the top casting. Use Vise Grips the top casting. Use Vise Grips® - - - - - NEVER NEVER NEVER NEVER NEVER use bare use bare use bare use bare use bare
hands - to handle a top casting under spring hands - to handle a top casting under spring hands - to handle a top casting under spring hands - to handle a top casting under spring hands - to handle a top casting under spring
tension.
tension. tension. tension. tension.
2. Take the top casting carefully out of the main support
arm (see NOTE below). Slowly let the torsion spring
unwind completely. Repeat Steps 1 & 2 for the opposite
end.
NOTE NOTE
NOTE NOTE NOTE: If the awning's right-hand torsion assembly has
been pinned (5000 & 7000 Models), the cotter pin must be
removed from the torsion assembly before the spring can
be unwound. If the awning is an 8000, 8500, 9000, 9500 or
Grande Pavilion Model, the cam lock lever on the right-
hand torsion assembly must be turned clockwise to the roll
up position, before the spring can be unwound.
MAIN SUPPORT ARM
LOCKING
TAB
FIG. 3A 7000 MODEL AWNING 7000 MODEL AWNING 7000 MODEL AWNING 7000 MODEL AWNING 7000 MODEL AWNING FIG. 3 5000 MODEL AWNING 5000 MODEL AWNING 5000 MODEL AWNING 5000 MODEL AWNING 5000 MODEL AWNING
COTTER PIN
MAIN SUPPORT ARM
LOCKING
TAB
COTTER PIN
LOCK
LEVER
TOP
CASTING
MAIN SUPPORT
ARM ASSEMBLY
VISE-
GRIPS®
1/4-20 X 1/2" HEX
HD. MACH. SET SCREW
FIG. 4