A&D SJ-15KWP, Инструкция по эксплуатации

Страница: 20 / 48

18
10.
WIRELESS COMMUNICATION FUNCTION
(SJ-WP-BT model only)
The SJ-WP-BT model has a wireless communication function.
Please purchase optional a wireless communication receiver separately.
This product is not paired with the wireless receiver at the time of shipment. In order to
use, it is necessary to perform the procedure in "10.1.Wireless Communication Initial
Setting" below.
The SJ-WP-BT model can be paired with one wireless communication device.
Note
The wireless communication function is a built-in option already incorporated at the time of
factory shipment. Therefore, please note that it can not be added to a SJ-WP model later.
10.1. Wireless Communication Initial Setting
While the power is off, press and hold the "connection switch" of the wireless communication
receiver until the LED lights in orange. (About 3 to 4 seconds)
Turn on the power and wait for a while. If there are multiple scales or balances, turn off the
power of those other than the one to be connected. When pairing is successful, the "Wireless
communication mark" lights up on the display. If the connection is not successful, please refer
to the owner's manual of the wireless communication receiver.
10.2. SJ-WP-BT Wireless Communication Specification
Transmission format Start-stop synchronous communication(asynchronous), Bidirectional,
Half duplex transmission
Signal format Baud rate 2400bps
Data bit 7 bit
Parity EVEN
Start bit 1 bit
Stop bit 1 bit
Usage code ASCII
Terminator C
R
L
F
(C
R
: 0Dh, L
F
: 0Ah)
LSB
0 1 2 3 4 5
MSB
6
Stop bit
Start bit Data bit Parity bit