A&D RA3100 Omniace, Простое руководство пользователя

Страница: 27 / 76

3.Flow of Measurement- 3.1.Flow of Measurement
1WMPD4004445 27
3. Flow of Measurement
This product records and play back input signals following the procedures described below.
3.1. Flow of Measurement
Perform the check
before applying power
and turn on the power.
Chapter 2
Confirm that this product has been set in a safe place, and that all the
accessories are properly attached.
Lower the
measurement range,
and connect the
signal.
Chapter 4
Note that applying a voltage greater than the maximum allowable
input voltage specified by the sensitivity setting of each input module
may cause damage to the main unit or internal components.
Set the input channel
while viewing the
monitor waveform.
Chapter 4.2
Configure the input channel settings to the conditions for recording.
Set the measurement range, filter, display position, display range, and
the sampling speed in the time axis direction.
Set the recording
device and sample
speed according
to the target for
measurement.
Chapter 4.3
Set the sampling speed and the recording device to save, as well as
the recording time, speed of input signal changes (frequency), and
whether to perform analysis after recording, etc.
Printer : Low-speed long-term measurement with only the
waveform recorded
SSD : Medium-speed long-term measurement for various uses
Memory : High-speed enlarged display of transient phenomena and
abrupt phenomena
Set the triggers.
Chapter 5
Set the triggers for starting recording.
Start and end
measurement.
Chapter 6
Press the START key on the operation panel to start measurement
and record the specified time and data count, and press the STOP
key to end measurement.
Playback and analysis.
Chapter 7
Use the PLAYBACK key on the side menu to playback recorded
data,
the DATA key on the control bar to select data,
and the X
- Y key and FFT key on the control bar to perform
data analysis.