A&D FG-CWP Series, Быстрый старт

Страница: 8 / 52

8
EN
When using in a place where static electricity is likely
to be generated or in a wet place, join the grounding
wire to the protective grounding terminal (screw).
6. Maintenance
・
Refer to “2. Cautions” regarding use.
・
Refer to "6.2.Check Points Before Calling Maintenance Service" and corresponding mode for
displayed error code.
・
Refer to the [FG-CWP Series Instruction Manual] on our website https://www.aandd.jp for sensitivity
adjustment.
・
Periodically check the accuracy of weighing. Adjust the scale, if it is moved to another location or the
environment has changed.
6.1. Repair
Do not disassemble / assemble the scale without an authorized service engineer. Doing so may
cause an electric shock or damage to the scale, etc. In this case, repair is not covered under
warranty. Contact your local A&D dealer if your scale needs service or repair.
6.2. Check Points Before Calling Maintenance Service
In this situation Confirm these items
Nothing displayed.
Scale does not turn on.
・
Is the main power the correct voltage?
・
Is the main power cord properly connected?
The scale does not
display zero at first.
・
Check around the weighing pan.
・
Is there anything on the weighing pan?
・
Refer to the [FG-CWP Series Instruction Manual] on our website
https://www.aandd.jp and perform zero point sensitivity adjustment.
e
is displayed.
・
Weighing error that meaning "Over loaded."
lo ut
is displayed.
・
Indicates that the sample weight is too light to set the unit weight in
the counting mode.
-Cal e
is displayed.
・
Sensitivity adjustment error that meaning "Too light."
lb
is displayed.
・
Displayed when the main power drops.
Fixed display.
・
Did you use the "hold function" ?
Refer to the [FG-CWP Series Instruction Manual] on our website
https://www.aandd.jp and change the function
Hold
.
・
Turn off scale and turn it on again.
Protective
Grounding
Terminal
Rear of Display Unit