A&D FC-10Ki, Инструкция по эксплуатации

Страница: 26 / 64

24
5. USING THE M+ MEMORY 5. USING THE M+ MEMORY 5. USING THE M+ MEMORY 5. USING THE M+ MEMORY
5-1. The M+ Memory Function 5-1. The M+ Memory Function 5-1. The M+ Memory Function 5-1. The M+ Memory Function
q
The scale can accumulate count data by pressing the M+ key, or automatically
(refer to the next page). It also keeps track of the number of times you add to the total.
q
When you view the total by pressing the TOTAL key, you view the number of
pieces accumulated and the number of additions (how many times the total was
added to). Please refer to “
5-2 5-2 5-2 5-2....
” and “
5-3. 5-3. 5-3. 5-3.
” to view or clear the total count.
Adding Using the M+ Key
Adding Using the M+ Key Adding Using the M+ Key
Adding Using the M+ Key
q
When stable count data is displayed:
1. Press the M+ key.
The
#
M+
indicator will blink for a few seconds.
If the scale beeps 4 times, or the
#
M+
indicator did not blink, then refer to the
note below.
The
#
M+
indicator will stay ON while
there is count in memory.
2. Press the M+ key every time you want to add
to the count. Remember that you may only add
the count data once – the scale must return to
near zero before it will let you add again.
To Erase the Last M+ Addition To Erase the Last M+ Addition To Erase the Last M+ Addition To Erase the Last M+ Addition
1. Press and hold the C key, then press
the M+ key – release.
2. The scale will clear the last
M+
addition.
If the scale beeps 4 times, there is no
M+
addition to erase.
# # # # # # #
888- 123
&&
F?I
!
2 A W E I G H T ( k g )
123456178 13.655 4
!
2 3 S A A M U U W ( g ) 1 2
12345617 111.000
#
123
M+
M+
A/a
q
The M+ key is accepted only once for every stable count data.
Once accepted, the M+ key is prohibited until the display
returns to less than +5d (1d = 1 weighing division).
q
If
f-03-02
is set at “1”, then the M+ key can accumulate
negative data. Once the M+ key is accepted, weight data must
return within ±5d before the next accumulation.
q
To store the total count in the ID number, refer to “
4-4. Unit
4-4. Unit 4-4. Unit
4-4. Unit
Weight, Tare, Comparator Limits & Total Count Stored Weight, Tare, Comparator Limits & Total Count Stored Weight, Tare, Comparator Limits & Total Count Stored Weight, Tare, Comparator Limits & Total Count Stored
”.
q The total count is not stored in the ID memories automatically
even if it was recalled by ID number.
C
+
M+
A/a