Raptor MicroATX – Installation Guide
8
ATA-Disk Connector Voltage Selection
The ATA-Disk Connector J41 can provide either 5Vcc or 3.3Vcc. The
jumper JP15 selects the voltage.
Table 1-10 ATA-Disk Connector Voltage Select
ATA-Disk
Voltage
5Vcc
3.3Vcc
JP15 1-2*
2-3
*Manufacturer's Settings.
LCD Panel Voltage Selection
The LCD panel connector J40 can provide either 5Vcc or 3.3Vcc to the
LCD panel. The jumper JP17 selects the voltage.
Table 1-11 LCD Panel Connector Voltage Select
LCD Panel
Voltage
5Vcc
3.3Vcc
JP17 1-2
2-3*
* Manufacturer's Settings.
On-Board Chipset I2C Connection to EDID
EEPROM
The On-Board EEPROM that contains EDID information of LCD
Panels may be Enabled or Disabled. The jumper JP16 selects the
option.
Table 1-12 On-Board EDID EEPROM Select
On-Board
EDID
Enabled
Disabled
JP16 1-2*
2-3
* Manufacturer's Settings.
Содержание Raptor MicroATX
