I
NSTALLATION DIAGRAM
S
TEP 1
S
TEP 2
Reference picture of bracket positions for later steps. Locate and align brackets base on the following picture.
There are four sets of threaded holes in the side panel. Starting from the front of the vehicle, use the First, Second
and Fourth set of holes.
R
emove the existing factory bolts, (if equipped) on the side panel located by the front tire opening, (Fig 1). NOTE: There is
a threaded hole next to the factory bolt, (if equipped). This will be the mounting location for the driver side front Mounting
Bracket. Partially attach the driver side front Mounting Bracket to the vehicle using the included
Hex Head Bolt M8,
Washers M8, and Spring Washers M8(Fig 2).Do not tighten at this time.
FIG1
Rear Bracket
Center Bracket
Front Bracket
Rear Bracket
Center Bracket
Front Bracket
PASSENGER SIDE
DRIVER SIDE
R
emove this
factory bolt
F
ront Bracket
Mounting Location
FIG2
B
RACKET FACING REAR OF VEHICLE
H
ex Hea Bolt(M8)
&
Spring
Washer(M8)
&
Washer(M8)
DRIVER SIDE
F
RONT OF VEHICLE
R
EAR OF VEHICLE
I
NSTRUCTION MANUAL
AAPRODUCTS INC.
F
or Technical Support Call:1-888-806- 3972 / 626-332-4245
