8
Safety Information
Please make sure water will not back up into the unit before use. Water will damage
internal components of the unit, and will not be covered by the unit’s warranty. Please
follow these steps when installing your unit:
1.
Install the unit above water level and as high as possible.
2.
Mount the unit so the tube, light and wires are toward the ground (disregard the
front label).
3.
Install the check valve according to the arrow on the check valve.
a. The arrow should face toward the injector.
4.
You will need an injector for injecting ozone into the water line. If you do not have an
injector, please contact us to purchase one. The unit does not work without an injector.
5.
At this point, a vacuum should be created and the suction can be felt on the tube.
6.
The Aquatic 2 should be on ONLY when the pump is ON. If your spa did not have an
ozonator, then connect the ozone electric wire to the pump wires.
Figure 3
Installing the Aquatic 2
