1. Be sure the MOTOR and HEAT switches are in the “OFF”
position. (Cord should also be unplugged from outlet.)
2. Allow the SPINNING HEAD unit and components to cool
down to a temperature that is safe to the touch.
3. Remove the four retaining nuts and leather floaters on the top
of the SPINNING HEAD unit.
4. Remove the top from the SPINNING HEAD unit by lifting it off.
5. Remove the slinger plate by loosening the two nylon acorn
nuts in the center.
6. Disconnect the two heater lead terminations by removing the
two nuts (3/8” Hex) and removing the leads from the studs.
7. Remove the outer screen assembly with the heating element
by sliding it straight up.
8. The top and the screen assembly with heating element
can be cleaned by immersing in hot water and mild detergent.
9. The head base is now accessible for removing the sugar
residue by manual cleaning with a damp cloth.
10. After allowing the components to dry completely, the screen
assembly with heating element can be reassembled by
placing the items on the head base.
11. Reconnect the two heater lead terminations with the two nuts
(3/8” Hex) be sure to route the wire leads as to avoid any
sharp bends.
12. Reinstall the slinger plate using two nylon acorn nuts.
13. Reassemble the top and secure with the four retaining nuts.
Leather floater should be installed on two opposing studs.
211 PEACH WAY, COLUMBIA, MO 65203 • 575.474.7881
|
323 MIDLAND DRIVE, JEFFERSON CITY, MO 65101 • 573.635.1516
WWW.A1PARTYFUN.COM • [email protected]
CLEANING:
