SHUTTING DOWN:
1. Press the HEAT switch to the “OFF” position.
2. Wait 3-5 minutes for the spinner head to cool down.
3. Press the MOTOR switch to the “OFF” position.
4. For end of day procedures, operate the machine until the
remaining sugar floss in the head is gone, and then do steps 1-3.
5. If the machine is to be moved, retighten the two shipping
knobs to prevent damage to the head during transit.
(Note: Some smoking may appear as the head is run out of sugar.
This is normal and will clean any residual sugar from the screen.)
1. Bad vibration.
- Verify that the shipping travel knobs are loosened.
- Check to make sure there are no sugar lumps in the
spinning head.
- Be sure machine is located on a firm and level surface.
2. Motor does not operate, but heater is operating.
- Motor protection has tripped off. Wait one minute and
then restart.
3. Floss is being formed with clumps of sugar or floss is forming,
but being cut.
- HEAT CONTROL is set at too high of a setting, lower
HEAT CONTROL setting.
4. Head is full of sugar but no floss comes out.
- Check the setting of the HEAT switch and HEAT CONTROL
- Empty head and follow routine cleaning procedures.
211 PEACH WAY, COLUMBIA, MO 65203 • 575.474.7881
|
323 MIDLAND DRIVE, JEFFERSON CITY, MO 65101 • 573.635.1516
WWW.A1PARTYFUN.COM • [email protected]
TROUBLESHOOTING:
