06/2021
Page 17
Installation and Operating Instructions
UPS Edition One 6kVA, 10kVA
4.3 Parameter settings
The setting function is controlled by 4 keys (ENTER/ON, ESC/OFF, UP, DOWN):
■
ENTER/ON – goes to the setting page and value setting;
■
UP & DOWN – to select different pages.
After switching on the UPS, press the UP and DOWN buttons for 3 seconds and then
switch to the settings page. Press the UP or DOWN button to select the desired setting
parameter.
Press Enter/On to enter the value setting status, press the UP or DOWN key to set the
value. Press the ON key to confirm. Press and hold the DOWN key until the setting
parameter is exited and saved.
4.3.1 Mode-setting
Mode setting:
(
NOTE:
Inside the broken-line is the flashing part)
After confirming the settings menu, the mode setting is preset as shown in the picture
above.
■
Press ENTER/ON to enter the value setting status, press UP & DOWN to select different
modes and press ENTER/ON to confirm.
■
Use the UP & DOWN keys to access the setting of the output voltage or the setting of
the parallel redundancy quantity.
