a-them AVM 60, Руководство по эксплуатации

Страница: 36 / 66

28
3.7
NETWORK / REMOTE CONTROL
NETWORK STATUS
This displays the AVM/MRX’s IP address once connected to the local area network.
DEVICE NAME:
This is the name that the AVM/MRX broadcasts, and can be changed using up to 16
characters.
Network / Remote Control
Network Status
Device Name
AVM 60
Wireless Setup
IP Configuration
Trigger Configuration
TCP Port
14999
Rear IR On
Front IR On
Tx Status On
Control4 ID Tx
WIRELESS SETUP
Wireless network connection can be set using various methods.
FROM PLAY-FI APP
The DTS Play-Fi app for iOS, Android, and Kindle devices streams music to your system
from local and internet sources. It also connects your AVM/MRX to your wireless network
as follows:
1. Install the app on your mobile phone or tablet.
2. Launch the app. It will look for Play-Fi devices - make sure your AVM/MRX has
been on for at least a minute to allow its wireless functions to be ready.
3. When the app finds your AVM/MRX it will temporarily disconnect your mobile
device from the wireless network while connecting it directly to the unit, and it will
ask you to enter your wireless network password. Once you enter it, the app will
send it the AVM/MRX so it can connect to your network.
4. Once the AVM/MRX is connected the app re-connects your mobile device to your
network and over the next minute searches for more Play-Fi devices. If it says that
not Play-Fi devices are on your network, turn your AVM/MRX off and on again,
wait a minute, and tap Search Again in the app.
5. Rename the AVM/MRX as you would like it to appear in the app, for example
“Main System”.
If the app has trouble finding the AVM/MRX at all, make sure that it has adequate wireless
signal strength by placing it close to the router. As well, make sure your mobile device is
near the AVM/MRX when it is searching for devices. If the AVM/MRX still cannot be found,
reset the wireless settings as described below and/or temporarily connect a CAT5 cable
between the AVM/MRX and the router until Play-Fi setup is completed.
Wireless Setup
From Play-Fi App
Push-Button Setup
Manual Setup
Reset Wireless Settings