A-Tach # 50320
Designed for:
Chevrolet Cruze 2016 - 20__
A
-Tach
Mounts
NOTICE:
A-Tach Mounts
will not be responsible for
any damage to the vehicle or product due to the
installation and/or use of the product. The product has
been tested to fit securely to the listed vehicles.
Instructions are provided for your convenience.
You are responsible to determine if you have the
skill to attach the product without causing damage
to your vehicle or the product.
Read all instructions and view the photos before
attaching this product.
For best results, hold the vehicle mount over the place where the mount attaches to the dash
BEFORE
attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the
mount will appear to be a little too big or small for the intended location. The vehicle mount must be
installed
BEFORE
a device holder is screwed onto the vehicle mount.
Once screwed together the products are considered used and non-refundable.
The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.
Once it is attached, it should remain attached until you would like to permanently remove it.
WARNING:
AVOID extreme heat conditions. It can damage the device and the mount.
(1) Clean the area where the mount will attach. The
left edge of the mount will attach into the seam
between the left side of the left frame around the
display and the inside of the vent illustrated with
the arrows in the photo above.
(2) The right edge of the mount will go into the
seam between the display and the left frame
around the display illustrated with the arrows in
the photo above.
(3) Use the seam tool if needed to open the left
seam a little.
(4) Remove the covering from the tape. Insert the
thin left edge of the mount into the seam next to
the seam tool.
See additional instructions on the back side.
